Advertisement
Quick Links
Advertisement
Related Manuals for Inkbird IBS-P01R
Summary of Contents for Inkbird IBS-P01R
- Page 1 说明书 骑马订 尺寸： ��mmX��mm...
- Page 2 IBS-P01R Wireless Pool Thermometer Introduction Parameters Basic Operation...
- Page 3 1. Introduction Measured Water Temperature Channel Number Temperature Unit Indoor Humidity Indoor Temperature Receiver(Temperature&Humidity Monitor) - 1 -...
- Page 4 Measured Water Temperature Max/Min Temperature Pool Thermometer 2. Parameters Battery: 4*AAA 1.5V Battery(not included) Transmission Frequency: 433Mhz Transmission Distance: up to 300 ft in open - 2 -...
- Page 5 space, if there is interference, the transmission distance will be limited. Receiver: Temperature Measurement Range: -10℃~60℃ (14℉~140℉) Temperature Measurement Accuracy: ±1.0℃ (±1.8℉) Temperature Display Accuracy: 0.1℃(0.1℉) Humidity Measurement Range: 0~99％ Humidity Measurement Accuracy: ±5％ Humidity Display Accuracy: 1％ Wireless pool Thermometer: Temperature Measurement Range: -40℃~70℃...
- Page 6 3. Basic Operation 3.1Buttons 3.1.1 Receiver CH/R: The device support max 3 transmitters at a time, you can press the button to switch between the channels(CH1, CH2, CH3, CH8), the screen will display the measured water temperature of the chosen one(CH1, CH2, CH3). If CH8 is selected, the measured temperature of CH1, CH2, and CH3 will be displayed for 5 seconds each alternately.
- Page 7 Note: Please put the pool thermometer as close as to the receiver during synchronization. MAX/MIN/CLEAR: Press the button to check the history maximum and the history minimum temperature of the pool thermometer. Hold the button for 5 seconds to clear the history temperature data, the device will record the new maximum and minimum temperature after clearing the history data.
- Page 8 3.1.2 Wireless Pool Thermometer Twist off the lid of the thermometer as shown below, all the buttons of the pool thermometer are designed inside. Clear/℃/℉: Press the button to clear the history temperature data, the device will record the new maximum and minimum temperature after clearing the history data.
- Page 9 to the receiver manually, the blue light of the pool thermometer will flash once when the transmission is successful. Hold the button for 5 seconds to reset the pool thermometer and disable the synchronization, reinstall the batteries of the pool thermometer, it will synchronize with the receiver automatically within 2 minutes.
- Page 10 Once the receiver is successfully synchro- nized with the pool thermometer, the receiver will display the measured temperature of the pool thermometer and record the registration information of it. Users will not have to repeat the synchronization steps after restarting the receiver.
-
Page 11: Battery Installation
3.2.2 Reset Hold the TX button of the pool thermometer for 5 seconds to reset the synchronization between it and the receiver. Follow the steps of 3.2.1 to re-synchronize the pool thermometer and the receiver. 3.3 Battery Installation Unscrew the lid of the pool thermometer as shown below. - Page 12 Remove the battery cover, install 2 AAA batteries, put the cover back. - 10 -...
-
Page 13: Fcc Requirement
Make sure the silicone waterproof ring is well placed, then close and tighten the lid of the pool thermometer. FCC Requirement changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. - Page 14 interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
- Page 15 one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Page 16 INKBIRD TECH.C.L Support@inkbird.com www.inkbird.com +86-0755-22747857 4/F E, Bldg 713, Pengji Industrial Zone, Liantang St, Luohu Dist., Shenzhen, China.
Need help?
Do you have a question about the IBS-P01R and is the answer not in the manual?
Questions and answers