Operation; Starting Cold Engine - Echo ES-210 - SERIAL NUMBER 07001001-07999999 Operator's Manual

12
O
PERATION
• Provide all operators of this equipment with the Operator's Manual
and instructions for safe operation.
• Before starting the unit, equip yourself and any other person working
within the 15 m (50 ft.) Safety Zone with the required Protective
Equipment and clothing.

STARTING COLD ENGINE

1. Stop Switch - Start/Run.
Move stop switch button (A) away from the STOP position.
2. Move throttle position lever (B) midway between idle and full
throttle positions.
3. Close Choke - Cold Start.
Move choke (C) to Cold Start (
4. Primer Bulb -Pump.
Pump primer bulb (D) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
IMPORTANT
Recoil starter: Use short pulls - only 45 ~ 60 cm (18 ~ 24 in.) of rope
for starting. Do not allow the rope to snap back in. Always hold
the unit firmly.
5. Recoil Starter
Place the unit on a flat, clear area. Firmly grasp throttle grip with
left hand and rapidly pull recoil starter handle/rope (E) until engine
fires (5 pulls maximum).
6. Choke
After engine fires (or 5 pulls), move choke lever to "Run" (
position and pull starter handle/rope until engine starts and runs.
Allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in "Run" position after 5 pulls,
repeat instructions.
7. After engine warm up, gradually depress throttle trigger to
increase engine RPM to operating speed.
) Position.
)
A
B
C
D
E