Operation - Echo PB-200 Operator's Manual

OPERATION
CHECK UP OF NUTS AND OTHER HARDWARES
• Check up loose nuts, bolts and screws before using the unit every day.
FUEL
• Fuel used for this model is a mixture of regular grade gasoline and ECHO brand motor oil or an aircooled two stroke
engine oil of a reputable brand name.
• Mixture ratio is
Gasoline 32 parts: Oil 1 part.
iz: o — Fuel mixture at a ratio other than 32 : 1 may
cause malfunction of the engine*
(NOTE)
32:1 Ratio is applicable with special oil
approved by ECHO*
— Pour 1/2 gasoline into safe container, add oil and mix thoroughly.
— Now add the remainder of gasoline and mix again.
— Do not use motor oil other than that
recommended above.
— Do not mix directly in engine fuel tank.
(32 : 1)
Fuel mix chart
150 : D
US
METRIC
US METRIC
After refuel to tank, secure filler cap and GAS OIL GAS OIL GAL
OIL GAS OIL
wipe all spilled fuel with a dry cloth.
GAL FL 02
LITERS CC GAL.
FL 0Z LITERS CC
1
4.0
4
125
1
2.6
4
80
2
3,0 0 250 2 5.1
8 160
5
20.0
20
625
5 12.8
20
400
STARTING COLD ENGINE
• Stand engine upright on a level surface.
• ignition switch to "start/run" position.
• Turn choke shutter to START (close) position. (Towards the flexible pipe)
• Open throttle trigger to a fast idle. (Squeeze it slightly)
• Pull recoil starter until engine fires.
• Turn choke shutter to full RUN (open) position, and if necessary, start engine again and allow to warm up before using
(Caution)
Recoil starter: Use short pulls-only 1/2 —2/3 of the starter rope for starting.