Program; Repeat - Tangent CDP-200 Instruction Manual

Program

The CDP-200 can be programmed to play the tracks of a CD
in a certain order.
Press the MEMORY button when playback has been stopped.
The display will show the message "MEM01 = 01"
The number to the left is the total numbers of tracks
programmed.
The number to the right is the track number programmed to
the number in the programmed order.
Finish the programming by pressing PLAY.
For examble if you wish to program the track numbers 5, 8, 4
in this specific order the following must be done:
- Press the MEMORY button.
- Press the number 5 button.
- Press the ENTER button.
- Press the number 8 button.
- Press the ENTER button.
- Press the number 4 button.
- Press the ENTER button.
- Confirm the programming by pressing PLAY.
Press the STOP button and then the MEMORY once to
deactivate the programming function. Then the normal display
will return.
Note:
When you press I<< or >>I, you will select the next track in the
programmed order.

Repeat

The CDP-200 can be set to repeat one or all tracks of a CD.
This is done by means of the REPEAT button on the remote
control or the front panel.
If you press the button once, one track will be repeated and
the display will show REP 1.
If you press the button twice, all tracks will be repeated
the the display will show REP ALL
If you wish to deactivate the repeat function, press the
REPEAT button for a third time.
Note:
This function can also be used when "MEMORY" has been
activated.
OPERATION AND FUNCTIONS
and
CD
mem 01 = 01
CD
mem 01 = 05
CD
mem 02 = 08
CD
mem 03 = 04
CD
05
CD Rep 1
02
CD Rep all
02
17
00 : 01
04 : 26
04 : 26