Operation And Functions; On, Off And Standby; Load A Disc; Play - Tangent CDP-200 Instruction Manual

On, Off and standby

1 Turn on the unit by pressing the mains switch on the rear panel.
Then press the CD button on the remote, or the standby button on the front panel.
2 Press the standby button on the remote control to switch into standby mode. The display
will turn off and all functions will be reduced to a minimum to make sure that the unit uses
minimal power. When in standby mode the unit only reacts to the CD button of the remote
control(3).
4 If you wish to turn off the unit to avoid any power consumption, you must press the mains
switch on the rear panel.
STANDBY / ON
2

Load a disc

If you want to play a disc, you must load it. You do that by
pressing the eject button on the remote control or on the front
panel of the CD player.
When the disc has been read, the display will show the
number of tracks on the disc and the total playback time.
If there is not disc in the tray, the message "NO DISC" will be
displayed.

Play

Press the PLAY/PAUSE button on the remote control or on the
front panel once to start playback.
The counter on the left side of the display will start to count
upward.

OPERATION AND FUNCTIONS

CDP-200 CD-PLAYER
Protect the environment and turn off the unit after use.
CD
20
CD
01
14
POWER
2
1 2 3 4
5 6 7 8
9 0 10+
AUTOTUNE ST/MO MEMORY DISPLAY
CD DVD TUNER T MODE
3
AUX1 AUX2 AUX3 PHONO
STATION STATION
ENTER
TUNING TUNING
VOLUME
AUDIO SETUP MENU
SUBTITLE TITLE MUTE
REPEAT RANDOM SLOW
HIFI-200
64 : 26
no disc
00 : 01