Table of Contents
Advertisement
force you to connect the fan cable correctly (see Figure 17 below).
Figure 15
Figure 16
I
Figure 17
Installing the Passive Processor
The installation of the passive processor differs only slightly from that of the
active processor. Your passive CPU package should contain one CPU retention
module, one heat sink retention bracket with mounting locks, two mounting
attachments, and one heat sink lock.Install the retention module as explained in
the active processor section.
The heat sink mount (Figure 18 on the next page) has two pins on the bottom
and four pins on the top. Notice that the bottom two pins are of different sizes.
The size of the pins and the holes in the motherboard will determine the correct
orientation. When the bracket is correctly installed, the four pins on top will be
S1830 Tsunami AT
21
Advertisement
Table of Contents
