Table of Contents
Advertisement
Figure 3
Next, connect your IDE cables (if you're using IDE hard drives).
The colored stripe on the cable indicating pin 1 should face towrds the rear of
the case (towards the ATX connectors).
In Figure 4 (below) you can see how the IDE cables should look when they are
connected to your hard drive. Notice how Pin 1 (denoted by a red stripe) is
connected so that it is next to the power connector of the drive. In most cases,
this is the proper way of connecting your IDE cable to the hard drive. Figure 5
(on the next page) shows the IDE cable properly connected to the
motherboard.
Figure 4
S1830 Tsunami AT
13
Advertisement
Table of Contents
