TYAN TSUNAMI AT Manual page 11

Chapter 2
Board Installation
The plastic clip on the power connector should lock over the plastic tab on the
onboard connector. You shouldn't be able to plug the power connector in any
warning
other way but just to be safe, make sure it looks like Figure 2 above. Make
absolutely certain that you do not miss any pins because, if you do, you will
void your warranty and cause damage to yourself or your motherboard when
you turn the system on. After connecting the power, make sure the connector
is seated firmly into its socket so it will not become loose or fall off when the
computer is jostled or moved. Note: Tyan recommends using an ATX power
impor-
tant!
supply that conforms to industry standard revision 2.01.
If you decide to use an AT power supply instead, connect the power supply to
the board as shown in Figure 3 (Next page).
Note that the black wires are in the center of the two connectors. You should
not be able to plug the two power connectors in any other way but just to be
safe, make sure you have them connected as shown above. Make absolutely
certain that you do not miss any pins because if you do, you will void your
warranty and cause damage to yourself or your motherboard when you turn
the system on. After connecting the power, make sure the connectors are
seated firmly into their sockets so they will not become loose or fall off during
movement of the computer.
Figure 1 Figure 2
12
http://www.tyan.com