Delta 37-380 Instruction Manual page 9

2. Remove the four bolts that attach the motor (A) Fig.
5 to top of the stand. NOTE: SAVE THESE BOLTS AS
THEY WILL BE USED TO ATTACH THE MOTOR TO
THE MOUNTING BRACKETS.
3. Align the holes in the motor mounting plate (B) Fig.
5A with the four holes in the two motor mounting
brackets (C). Attach the motor to the motor mounting
brackets with the hardware that was removed in STEP 2.
NOTE: MAKE SURE THAT MOTOR SHAFT (D) FIG 5A
IS FACING OUT OF THE OPENING IN THE MOTOR
CABINET AS SHOWN.
4. Turn the stand over so that it is resting on its base
as shown in Fig. 6.
THE JOINTER IS EXTREMELY HEAVY.
HAVE TWO OR MORE PEOPLE LIFT THE MACHINE
O N T O T H E S TA N D O R L I F T T H E J O I N T E R
MECHANICALLY.
5. Line up three holes (F) and (L) Fig. 6, on top of stand
with three holes located at the bottom of the jointer
base. Place a 3/8" flat washer (H) Fig. 7, on a 3/8-16x2"
hex head screw (G), insert the screw through the hole in
the base of the Jointer and hole (F) Fig. 6, in the stand.
Place a 3/8" flat washer (H) Fig. 7, 3/8" lockwasher (J),
and thread a 3/8-16 hex nut (K) onto the screw and
tighten securely. Repeat this process for the remaining
hole (F) in the stand and Jointer base. Repeat this
process for hole (L) in the stand and Jointer base by
inserting the screw up through hole (L) in the stand and
the Jointer base.
ASSEMBLING INFEED TABLE
ADJUSTMENT HANDLE
1. Thread an M14x2 hex nut (A) Fig. 8, clockwise onto
the end of adjustment handle (B) as far as it will go.
2. Thread handle (B) Fig. 8, into block (C) which is
located under infeed table (D). Tighten hex nut (A) Fig. 8,
against block (C).
J
H
G
K
Fig. 7
B
C
F
D
A
9
A
Fig. 5
D
Fig. 5A
L
Fig. 6
C
B
Fig. 8