TYAN TOMCAT I815E Manual page 42

Chapter 3
BIOS Configuration
Plug & Play O / S
Reset Config Data
PCI Latency Tim er
Allocate IRQ to PCI VGA
Palette Snooping
PCI IDE Bus Master
OffBoard PCI / ISA IDE Card Specifies if an offboard PCI or ISA IDE
USB Function
Legacy USB Support
IRQ (3,4,5,7,9,10,11,14,15)
DMA Channel (0,1,3,5,7)
Reserved Mem ory Size
Indicates if you are using a PnP O / S.
[Default is No ]
If set to Yes, PCI / PnP data w ill be stored in
Flash on next boot. [Default is No ]
Specifies latency timings for PCI devices.
[Default is 64 ]
Informs PCI devices that an ISA graphics
device is installed in the system so the card
w ill function correctly. [Default is Yes ]
If set to Enabled, multiple VGA devices
operating on different buses can handle data
from the CPU on each set of palette registers
on every video device. [Default is Disabled ]
Specifies that the IDE controller on the PCI
bus has bus mastering capability. [Default is
Disabled ]
controller card is installed. [Default is Auto ]
Enables USB. [Default is Enabled ]
Enables legacy USB device support. [Default
is Auto ]
Allow s listed IRQ to be used by PCI / PnP
devices. [Default is Available ]
Allow s listed DMA to be used by PCI / PnP
devices. [Default is Available ]
Specifies size of memory area reserved for
legacy ISA adapter cards. [Default is
Disabled ]
42
http://www.tyan.com