TYAN TOMCAT I7230B Manual page 15

JP15: Front Panel Header
The Front Panel Header is used to connect some control or signal wires from
motherboard to chassis, such as HDD LED, power LED, power button, and
reset button.
HDDLED+
HDDLED-
Reset SW-
Reset SW+
External INT+
External INT-
+3V
SB
SMBUS Data
SMBUS Clock
JP16: Clear CMOS Jumper
Use this jumper when you forgot your system/setup
1
password or need to clear system BIOS setting.
3
Normal
How to clear the CMOS data
(Default)
-
-
1
-
3
Clear
-
J11: Tyan SO-DIMM Connector
Use this connector to connect the Tyan TARO card.
JP1/JP2: SMDC/ASF2.0 Select Header
Pin 1-2 Closed: Enable ASF2.0 support (Default)
3
1
Pin 2-3 Closed: Enable SMDC card support
1 3
1 2 PWR LED+
3 4 PWR LED-
5 6 PWR SW+
7 8 PWR SW-
9 10 Warning LED+
11 12 Warning LED-
13 14 N/A
Chassis Intr# (Active Low)
15 16
17 18 Chassis Intr# (Active Low)
Power off system and disconnect the power
supply from the AC source
Use jumper cap to close Pin 2 and 3 for several
seconds to Clear CMOS
Replace jumper cap to close Pin 1 and 2
Reconnect the power supply to the AC source
Power on system
15
http://www.tyan.com