Installation Accessories; Lnstallatron Procedure - Kenwood KTC-SRSOI Instruction Manual

Sirius satellite radio tuner
Table of Contents

Advertisement

The use of any accessones
except for those provided mtght result In damage to the unrt. Make
sure only to use the accessones
shipped wrth the unit, as shown above.
1.
2
3.
4.
5.
6.
7.
8.
To prevent short circuits, remove the key
from the ignition and disconnect the @
terminal of the battery.
Install the Sirius antenna and connect the
antenna wrre to the Sirius satellite radio
tuner.
Connect the Sinus satellite radto tuner and
the control unit usrng the provrded Stnus
connectron wrre.
Make the proper Input and output wire
connections for each unrt.
Connect the battery wrre and ground wire to
the Sirius satellite radio tuner.
Install the untt in your car.
Reconnect the 0 termrnal of the battery.
Press the reset button on the control unrt.
l
Do not connect the Sirius control wire
while the control unit IS turned ON.
l
Be sure to press the reset button on the
control unrt after installation.
l
If your car
IS
not prepared for thus specral
connection-system,
consult your
Kenwood dealer.
l
Make sure that all wire connectrons
are
securely made by inserting jacks until
they lock completely.
l
Some drsc changers need conversron
wires for connectron.
See the section on
"Safety Precautrons" for details.
l
Do not let unconnected
wires or
terminals touch metal on the car or
anythrng else conductrng electncrty. To
prevent short crrcurts, also do not
remove the caps on the ends of the
unconnected
wares or the termrnals.
l
If the fuse blows, first make sure that the
wires have not caused a short crrcurt, then
replace the old fuse wtth one with the
same rating.
l
Insulate unconnected
wires with vinyl
tape or other srmrlar material.
l
Take care so that the antenna wire and
other connectron wares are not caught by
mobile parts. Otherwrse wire
drsconnectron
or other trouble may
result.
l
Do not apply too much force on the
antenna wrre, other connectron wires
and connectors
by bendrng a wire, etc.
Otherwise
wire disconnection
or other
trouble may result.
l
After the unit IS Installed, check whether
the brake lamps, rndrcators, wrpers, etc.
on the car are workrng properly.
8 -English

Advertisement

Table of Contents
loading

Table of Contents