Installing Memory - TYAN TIGER 200T User Manual

2.8 Installing Memory

Please keep in mind that although some memory modules may appear to be high-quality, they may con-
tain inferior or substandard parts. The type of memory you choose to install should be checked against
the memory compatibility list, which is available from Tyan's website at http://www.tyan.com
Here are some details of memory installation for this board:
At least one non-registered, unbuffered DIMM must be installed in order to POST.
Supports 128MB, 256MB, 512, or 1024MB* buffered or unbuffered DIMMs.
All memory is automatically detected, there is no need to set any jumpers.
The motherboard supports up to 4GB* of buffered or unbuffered PC100 or133 SDRAM
Memory Installation Procedure
Line your module up so that the pins fit into the socket. There is only one way your DIMM can
1
Step
fit properly. Make sure that the short row of pins is lined up with the short gap in the DIMM
socket, just as the long row of pins should line up with the long gap in the DIMM socket.
Insert the DIMM by pushing the module into the socket with even force. Do not insert one
2
Step
end and then the other: install the whole module at once or you might bend the DIMM pins.
Make sure the DIMM is securely seated.
* Memory support dependent on operating system used. Check the Tyan website for updated details
on memory support for the Tiger 200T: http://www.tyan.com
Tiger 200T S2505T
short row of pins long row of pins
19