Setting Up Jumpers And Onboard Connectors; A Front Panel Connector; Bcmos Reset - TYAN TIGER 200T User Manual

2.6 Setting up Jumpers and Onboard Connectors

Pinouts for certain connectors are available on the Tyan website: http://www.tyan.com
2.6-A. Front Panel Connector (J12)
Your chassis will usually come with connectors to install onto
the motherboard, such as HDD and Power LEDs. The Front
Panel Connector (J12) has been implemented for such purposes.
2.6-B. CMOS Reset (JP8)
If you have been locked out of your system because you forgot your password, or set the CMOS incor-
rectly, or have just finished flashing your BIOS follow the instructions below.
1. Power off the system
2. Close pins 2-3 on JP8
3. Wait about three seconds
4. Close pins 1-2 on JP8, then power on the system again
By following this procedure, you will erase your password and reset the CMOS.
Tiger 200T S2505T
VCC+ 1 2 Pwr LED+
ground 3 4 Slp LED+
ground 5 6 switch
switch 7 8 ground
no connect 9 10 no connect
RX 11 12 VCC
GND 13 14 no connect
TX 15 16 no connect
no connect 17 18 DRIVER
Abbreviations
Rst Reset
Pwr Power
1-2
JP8
normal
* default is 1-2
2-3
clear
11