Volvo S60 Owner's Manual page 89

2006 Volvo S60
follow these instructions after programming the desired transceiver button according to "Programming
the transceiver." The help of a second person may make training easier.
1. Locate the training button on the garage door opener motor head unit. The location and color of the
training button may vary. If you encounter difficulty, refer to the garage door opener owner's manual or
call toll-free 1-800-355-3515 (Internet: www.HomeLink.com).
2. Press the "training" button on the garage door opener motor head unit until the "training" light comes
on.
3. Press and release the programmed HomeLink® button. Press and release the programmed
HomeLink® button a second time to complete the training process. Some garage door openers may
require you to do this procedure a third time to complete the training.
The programmed button on your HomeLink® Universal Transceiver should now operate your garage
door opener. The original hand-held transmitter can also be used, as desired, to operate the garage door.
The remaining two HomeLink® buttons can be programmed in the same way. In the event of any
problems in programming the HomeLink® Universal Transceiver, call toll-free 1-800-355- 3515
(Internet: www.HomeLink.com).
Operating the HomeLink® Universal Transceiver
Once programmed, the HomeLink® Universal Transceiver can be used in place of your handheld
transmitters.
To operate, the key must be turned to the "accessory" position (II) or the engine must be
pg. 196 Audio
running. Press the programmed HomeLink® button to activate the garage door, driveway gate, security
lighting, home security system, etc.
Your original hand-held transmitters may, of course, be used at any time.
Erasing programmed buttons
Individual buttons cannot be erased. To erase all three programmed buttons:
1. Turn the ignition key to the "accessory" position (II).
2. Hold down the two outside buttons on the HomeLink® Universal Transceiver for about 20 seconds,
until HomeLink®'s indicator light begins to flash.
3. Release both buttons.
The HomeLink® buttons can be reprogrammed using the procedures described on the previous page.
(HomeLink® information continues on the next page).
Reprogramming a single HomeLink® button
file:///K|/ownersdocs/2006/2006_S60/06s60_04b.htm (11 of 12)12/30/2006 4:47:12 PM