Attaching Load Carriers - Volvo S60 Owner's Manual

2006 Volvo S60
1. Remove the cotter pin from the locking bolt and slide the locking bolt out of the ball holder/hitch
assembly.
2. Pull the ball holder out of the hitch assembly.
A cover for the hitch assembly can be purchased from your Volvo retailer.
pg. 106 Starting and driving

Attaching load carriers

The attachment brackets for the load carriers are located under the roof molding.
1. Make sure that the load carriers are placed in the right direction. See the mark on the decal under the
cover.
2. Press the guide lugs into the holes (1).
3. Carefully lower the opposite side of the load carrier to the roof.
4. Loosen the tightening wheel slightly. Slide the hook on the load carrier attachment into the attachment
bracket under the roof molding.
5. Turn the tightening wheel to secure the load carrier in the attachment bracket.
6. Repeat this procedure for the other load carrier attachments.
7. Check that the hooks on all four load carrier attachments are securely tightened in the respective
attachment brackets on the roof of the car.
8. Press down the covers.
Check periodically that the load carriers and load are properly secured.
Load carriers (accessory)
Load carriers are available as Volvo accessories. Observe the following points when in use:
file:///K|/ownersdocs/2006/2006_S60/06s60_08b.htm (10 of 15)12/30/2006 4:47:16 PM
Load carrier