KYMCO XCITING 250 Owner's Manual page 53

3. Open the ignition key-hole shutter and make sure the
engine stop switch is at "
4. Turn the ignition switch to "
Confirm the red low oil pressure indicator is ON.
The low oil pressure indicator should go off a few
seconds after the engine starts. If the light stays on, stop
the engine immediately and check the engine oil level.
NOTE:
Operating the engine with insufficient oil pressure can
cause serious engine damage.
5. Squeeze the rear brake lever.
The electric starter will only work when the rear brake
lever is squeezed and the side stand is up.
" (RUN).
" (ON)
47