Comfort Glow CSBNT Owner's Operation And Installation Manual page 9

INSTALLATION
Continued
12"
Side Wall Minimum
Front View
12 "
Minimum
Side Wall
Front of Stove Unit
Top View
Corner
Wall
6 "
Minimum
Ceiling
48"
Minimum
Front of
Stove Unit
Floor
Side View
Figure 5 - Minimum Clearance to Walls
and Ceiling (Stove May Vary Depending
on Model)
111487-01D
Ceiling
48"
Minimum
12"
Minimum
Back Wall
6 "
Minimum
12 "
Minimum
Wall
6 "
Minimum
Front of Stove
Unit
Back Wall
6"
Minimum
www.desatech.com
CONNECTING TO GAS SUPPLY
WARNING: This appliance
requires a 1/2" NPT (National
Pipe Thread) inlet connection to
the pressure regulator.
Side Wall
WARNING: A qualified service
person must connect heater to gas
supply. Follow all local codes.
CAUTION: Never connect
propane/LP heater directly to the
propane/LP supply. This heater
requires an external regulator
(not supplied). Install the exter-
nal regulator between the heater
and propane/LP supply.
Side Wall
WARNING: Never connect
natural gas heater to private (non-
utility) gas wells. This gas is com-
monly known as wellhead gas.
Installation Items Needed
Before installing heater, make sure you have the
items listed below.
• external regulator [propane/LP only] (supplied
by installer)
• piping to stove location (check local codes)
• sealant (resistant to propane/LP gas)
• equipment shutoff valve *
• test gauge connection *
• sediment trap
• tee joint
• pipe wrench
* A CSA design-certified equipment shutoff valve
with 1/8" NPT tap is an acceptable alternative to
test gauge connection. Purchase the optional CSA
design-certified equipment shutoff valve from your
dealer. See Accessories, page 19.
The gas inlet connection for the stove heater is
located on the lower right-hand side of the stove
when viewed from the front of the unit. The gas
connection can be made either through the bottom
right side or through the lower back opening as
illustrated in Figure 6, page 10. Make sure gas log
heater is secured to the stove cavity assembly.
9