Removing And Installing Transmission - Porsche 928 Workshop Manual

37
Automatic Transmission/Controls, Case 928
REMOVING AND INSTALLING TRANSMISSION
Removing
5. Disconnect control cable on throttle
housing.
1. Unscrew battery ground strap on body.
2. Disconnect multiple pin plugs in spare
wheel well and pull out wires from below.
3. Remove upper and lower air cleaner
housings.
6. Disconnect oxygen sensor wire on central
fuse/relay panel and pull out from below
(USA cars).
7. Remove engine air guide.
8. Remove complete exhaust assembly with
shields.
9. Remove starter and suspend in suitable
position.
10. Drain ATF and remove reservoir.
11. Disconnect drive shafts on transmission
end and suspend on wire in horizontal
4. Remove upper air guide section.
oosition.
a
37 - 118 Removing and Installing Transmission
Printed in Germany