Beater To Bowl Clearance - KitchenAid KG25H0XMC Instructions And Recipes Manual

BEATER TO BOWL CLEARANCE

Your stand mixer is adjusted at the
factory so the flat beater just clears
the bottom of the bowl. If, for
any reason, the flat beater hits the
bottom of the bowl, or is too far
away from the bowl, you can correct
the clearance easily.
NOTE: Adjustments should be made
only with the flat beater in place.
1. Make sure the speed control
lever is set to the OFF/0 position.
2. Unplug the stand mixer or
disconnect power.
3. Place the bowl-lift lever in the
down position.
4. Attach the mixing bowl and
flat beater.
5. Gently turn screw (A) slightly
counterclockwise to raise the
bowl (reduced beater clearance),
or clockwise to lower the bowl
(increased beater clearance). A
slight turn is all that is required;
the full range of adjustment is
achieved in just
screw. Do not rotate the screw
more than / turn in either
1
2
direction.
/ turn of the
1
2
A
22 22 22 22
6. Raise the bowl into mixing position.
7. Examine the clearance between
the beater and the bowl. The
beater should just clear the
surface of the bowl. If it does
not, lower the bowl and readjust.
NOTE: When properly adjusted,
the flat beater will not strike the
bottom or sides of the bowl while
the mixer is running. If the beater
or professional wire whip strikes the
bowl, damage may result.
22