Beater To Bowl Clearance; Using The Bowl Guard - KitchenAid Commercial KSM8990WH Instructions Manual

our Stand Mixer is adjusted at the factory so the flat beater just clears the bottom of
the bowl. If, for any reason, the flat beater hits the bottom of the bowl or is too far away
from the bowl, you can correct the clearance easily.
1. Unplug Stand Mixer or disconnect
power.
2. Place bowl lift lever in down position.
3. Attach flat beater.
4. Adjust so flat beater just clears bottom
surface of bowl when in lifted position
by turning screw (A) counterclockwise
to raise the bowl and clockwise to
lower the bowl. Just a slight turn is all
that is required: the screw will not
rotate more than 1/4 turn (90 degrees)
in either direction. (The full range of
adjustment is 1/2 turn, or 180 degrees.)
5. Place bowl lift lever in up position
to check clearance.
6. Repeat steps 4 and 5 if necessary.
NOTE: When properly adjusted, the flat
beater will not strike on the bottom or
side of the bowl. If the flat beater or the
wire whip is so close that it strikes the
bottom of the bowl, the beater or whip
may wear.
If your Stand Mixer comes with a bowl
guard, make sure that the guard is returned
to the down position before beginning
to use the Stand Mixer. The Stand Mixer
will not run if the bowl guard is not in the
proper position.
*Included with select models. Picture may vary from product depending on model.
12

Beater to Bowl Clearance

Using the Bowl Guard*

Raise Bowl
A
Lower Bowl