Beater To Bowl Clearance - KitchenAid 5KSM180LE Owner's Manual

ATTACHING/REMOVING THE FLAT BEATER*, WIRE WHIP*, PASTRY
BEATER* OR DOUGH HOOK*
Unplug mixer before touching beaters.
Failure to do so can result in broken bones, cuts, or bruises.
1.
To attach accessory: Turn Speed Control Lever to off (0). Unplug Stand Mixer.
2.
Unlock and lift the Motor Head. Then, lock
3.
Slip accessory onto Beater Shaft and press upward as far as possible. Then, turn
accessory to the right, hooking accessory over the pin on the shaft.
4.
To remove accessory: Repeat steps 1 and 2. Press accessory upward as far as possible
and turn to the left. Then pull accessory from the Beater Shaft.
Scan code for more information

BEATER TO BOWL CLEARANCE

Your Stand Mixer is adjusted at the factory so the Flat Beater
Bowl. If, for any reason, the Flat Beater
Bowl, you can correct clearance easily.
1.
Turn Speed Control Lever to off (0). Unplug Stand Mixer.
2.
Lift Motor Head. Turn screw slightly counterclockwise (left) to raise Flat Beater
clockwise (right) to lower Flat Beater
surface of Bowl. If you overadjust the screw, the locking lever may not lock into place.
NOTE: When properly adjusted, the Flat Beater
Bowl. If the Flat Beater
coating may wear off the beater or wires on whip may wear.
**Locking option is available on select models.
*Also available as an optional accessory.
WARNING
Injury Hazard
**
hits the bottom of the Bowl or is too far away from the
*
. Make adjustment with Flat Beater
*
or the Wire Whip is so close that it strikes the bottom of the Bowl,
* *
the head to keep it lifted.
just clears the bottom of the
*
will not strike on the bottom or side of the
*
or
*
, so it just clears
*
7