Related Manuals for Nortel CS 1000E CP PII
Summarization of Contents
Introduction
Subject
Provides information on fiber-optic links connecting local systems to Remote IPE modules.
Applicable systems
Document applies to specific Nortel Communication Server 1000 models.
Intended audience
For individuals responsible for installing and maintaining Fiber Remote Multi-IPE units.
Related information
Lists information sources related to this document.
Product Description
Introduction
Describes the Fiber Remote Multi-IPE Interface, architecture, and hardware.
System overview
Explains Large Systems and Remote IPE modules for distributed systems.
System description
Details the Fiber Remote Multi-IPE Interface's role in connecting systems.
Fiber Remote Multi-IPE Interface physical architecture
Describes the physical setup and connection of interface units.
Fiber Remote Multi-IPE Interface options
Lists the four available Fiber Remote Multi-IPE Interface options.
Installation and Configuration
Introduction
Describes installation of Fiber Remote Multi-IPE Interface and fiber-optic links.
Preinstallation preparation
Covers site preparation, unpacking, and inventory.
Setting S1 and S2 switches at the local site
Configures interface units using S1 and S2 dip-switches.
Installing the Fiber Remote Multi-IPE Interface unit onto the wall
Details mounting the unit on the wall.
Connecting the fiber-optic link
Connects local and remote interface units via fiber-optic cable.
Connecting the power source
Details power connection options: DC or AC/DC.
Configuring the equipment
Covers configuration and administration of Remote IPE at local and remote sites.
Selecting the MMI terminal modes
Sets MMI terminal to Host SDI or MMI mode for tasks.
Remote IPE Acceptance Testing
Introduction
Verifies Remote IPE functions, features, and fiber-optic link operation.
Checking the system
Visually inspects Remote IPE cards and observes LEDs for correct operation.
Performing acceptance testing
Verifies fiber-optic equipment function via calls and MMI terminal use.
Voice calls
Tests basic system features using voice calls between terminals.
Checking link protection switching
Tests manual and forced switch-over for redundant fiber-optic links.
Remote IPE Maintenance
Introduction
Describes maintenance tools and procedures for identifying and correcting faults.
Diagnostic tools
Used to troubleshoot system and interface unit problems.
Hardware diagnostic tools
Lists recommended and optional test equipment.
Superloop and Controller cards maintenance commands
Commands for manipulating status and performing diagnostic tests.
Remote IPE fault isolation and correction
Encompasses fault isolation for cards and interface units.
Replacing Remote IPE equipment
Covers removing and replacing defective cards or entire units.
Appendix: Peripheral Controller HEX codes and cable connection diagrams
Peripheral Controller hexadecimal codes
Lists Peripheral Controller HEX messages displayed during self-test.
Fiber Remote Multi-IPE Interface units connection diagrams
Illustrates connection diagrams for local and remote sites.
Need help?
Do you have a question about the CS 1000E CP PII and is the answer not in the manual?
Questions and answers