IBM THINKPAD T60 - SERVICE AND Service And Troubleshooting Manual page 22

Solving computer problems
Message
1810: Hard disk
partition layout
error
2100: Initialization
error on HDD0
(Main hard disk
drive)
2102: Initialization
error on HDD1
(Ultrabay hard disk
drive)
2110: Read error on
HDD0 (Main hard
disk drive)
2112: Read error on
HDD1 (Ultrabay
hard disk drive)
The power-on
password prompt
14
®
ThinkPad T60 Service and Troubleshooting Guide
Solution
A problem in recognizing the layout of the partition on the
hard disk has halted computer startup. Either the Predesktop
Area has been deleted, or the hard disk contains corrupt data.
To try to restart your computer, complete one of the following:
v If the Predesktop Area has been deleted
1. Press F1 to open the BIOS Setup Utility.
2. Select Security -> Predesktop Area -> Access Predesktop
Area.
3. Set this item to Disabled.
4. Save and exit.
v If the above fails
1. Press Enter.
2. Double-click RECOVER TO FACTORY CONTENTS and
follow on-screen instructions.
Note: This will permanently erase the entire contents of the
hard disk, and then restore software preinstalled by Lenovo.
Press F1 to open BIOS Setup Utility, or Enter to start the
Predesktop Area.
If the computer still does not start, call the Customer Support
Center. Telephone numbers are listed in "Worldwide telephone
list" on page 55.
The hard disk is not working. Have the hard disk serviced.
The hard disk is not working. Have the hard disk serviced.
The hard disk is not working. Have the hard disk serviced.
The hard disk is not working. Have the hard disk serviced.
A power-on password or a supervisor password is set. Type
the password and press Enter to use the computer. If the
power-on password is not accepted, a supervisor password
might have been set. Type the supervisor password and press
Enter. If you still see the same error message, have the
computer serviced.