Errors Without Messages - IBM THINKPAD T60 - SERVICE AND Service And Troubleshooting Manual

Hide thumbs Also See for THINKPAD T60 - SERVICE AND:
Table of Contents

Advertisement

Errors without messages

Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
When I turn on the machine, nothing appears on the screen and the
machine does not beep while starting up.
Note: If you are not sure whether you heard any beeps, turn off
the computer by pressing and holding the power button for more
than 4 seconds; then turn it on and listen again. If you are using an
external monitor, see "Computer screen problems" on page 20.
If a power-on password is set, press any key to display the
power-on password prompt, and then type the correct password
and press Enter.
If the power-on password prompt does not appear, the brightness
level might be set to minimum brightness. Adjust the brightness
level by pressing the Fn+Home.
If the screen still remains blank, make sure that:
v The battery is installed correctly.
v The ac adapter is connected to the computer and the power cord
is plugged into a working electrical outlet.
v The computer power is on. (Turn on the power switch again for
confirmation.)
If these items are properly set, and the screen remains blank, have
the computer serviced.
When I turn on the machine, nothing appears on the screen, but I
hear two or more beeps.
Make sure that the memory card is installed correctly. If it is, but
the screen is still blank, and you hear five beeps, have the computer
serviced.
If you hear 4 cycles of 4 beeps each, the Security Chip has a
problem. Have the computer serviced.
When I turn on the machine, only a white pointer appears on a
blank screen.
Reinstall your operating system (see Chapter 4, "Recovery options,"
on page 27) and turn on the computer. If you still see only the
pointer on the screen, have the computer serviced.
My screen goes blank while the computer is on.
Your screen saver or power management may be enabled. Move the
TrackPoint or press a key to exit the screen saver, or press the
power switch to resume from standby or hibernation.
Solving computer problems
Chapter 3. Solving computer problems
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents