Dell PowerVault MD3220 Owner's Manual page 76

NOTE:
7 Select the e-mail tab to configure the e-mail destinations.
• Adding an e-mail address—In e-mail address, type the e-mail address,
and click Add.
Replacing an e-mail address—In the Configured E-mail addresses
•
area, select the e-mail address to be replaced, type the replacement e-
mail address in E-mail address, and click Replace.
Deleting an e-mail address—In the Configured E-mail addresses area,
•
select the e-mail address, and click Delete.
• Validating an e-mail address—Type the e-mail address in Email
address or select the e-mail address in the Configured E-mail
addresses area, and click Test. A test e-mail is sent to the selected e-
mail address. A dialog with the results of the test and any error
appears.
8 For the selected e-mail address, in Information To Send, select:
• Event Only—The alert e-mail contains only the event information.
This alert type is the default.
• Event + Profile—The alert e-mail contains the event information and
the storage array profile.
• Event + Support—The alert e-mail contains the event information
and a compressed file that contains complete support information for
the storage array that has generated the alert.
9 For the selected e-mail address, in Frequency, select:
• Every event—Sends an alert e-mail whenever an event occurs. This is
the default option.
• Every x hours—Sends an alert e-mail after the specified time interval
if an event occurred during that time interval. You can select this
option only if you have selected either Event + Profile or Event +
Support in the Information To Send drop down list.
10 Click OK.
An alert icon appears next to each node in the Tree view where an alert is
set.
To ensure that the e-mail is sent successfully:
76
Configuration: About Your Storage Array
Including the contact information in the e-mail alert is optional.