Acoustic Error Messages; Error Messages On The Screen - Fujitsu FPCM11383 Easy Manual

Troubleshooting and tips

Acoustic error messages

Cause
A beep sounds every few seconds
The battery is almost flat.

Error messages on the screen

This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programmes are described in the relevant documentation.
If the error message appears repeatedly, despite troubleshooting measures, please
i
contact the place of purchase or our customer service centre.
Error message/cause
CMOS Battery Bad
If the error message occurs
repeatedly, the buffer battery in the
notebook is flat.
System CMOS checksum bad –
Default configuration used
The system configuration information
is incorrect.
Extended memory failed at
offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory
an error has resulted at the address
xxxx.
Failure Fixed Disk n
The settings of the hard disk drive are
incorrect.
Keyboard controller error
92
Troubleshooting
► Charge the battery.
Troubleshooting
► Please contact your sales outlet or our customer
service centre.
► Switch the notebook off.
► Switch the notebook on.
► Enter the BIOS Setup by pressing F2 .
► Select the Exit menu in the BIOS Setup.
► Select the entry Load Setup Defaults.
► Select OK and press the Enter key.
► Check whether the additional memory module has
been inserted correctly.
► Start the BIOS Setup (Primary Master submenu) and
select the correct settings.
► Switch the notebook off with the ON/OFF switch.
► Wait 3 to 5 seconds and switch the notebook back
A26391-K220-Z227-1-7619, edition 1