Brocade Communications Systems 1606 Administrator's Manual page 160

3
Configuring a multi-path Crypto LUN
FIGURE 57
The following steps may be used to configure multiple path access to the LUN in
1. Create zoning between host port 1 and target port 1. Refer to the section
2. Create zoning between host port 2 and target port 2. Refer to the section
3. On the group leader encryption switch (switch 1), create a CryptoTarget container for each
142
A LUN accessible through multiple paths
- target zone" on page 118 for instructions.
- target zone" on page 118 for instructions.
target port and add the hosts in sequence. Do NOT commit the configuration until you have
created all CryptoTarget containers and added all hosts to the respective containers.
a. Create a CryptoTarget container (CTC1) for target port 1 to be hosted on the encryption
engine of encryption switch 1. Refer to the section
page 123 for instructions on steps b. through e.
FabricAdmin:switch>cryptocfg --create -container disk CTC1 \
<switch 1 WWN> 0 <Target Port 1 WWN> <Target NWWN>
b. Create a CryptoTarget container (CTC2) for target port 2 to be hosted on the encryption
engine of encryption switch 2.
FabricAdmin:switch>cryptocfg --create -container disk
<switch 2 WWN> 0 <Target Port2 WWN> <Target NWWN>
Figure
"Creating an initiator
"Creating an initiator
"Creating a CryptoTarget container"
CTC2 \
Fabric OS Encryption Administrator's Guide
57.
on
53-1001864-01