Tape Pools Tab - Brocade Communications Systems 1606 Administrator's Manual

2
Viewing and editing group properties
Adding tape pools
A tape pool can be identified by either a name or a number, but not both. Tape pool names and
numbers must be unique within the encryption group. When a new encryption group is created, any
existing tape pools in the switch are removed and must be added.
1. Select Configure > Encryption from the menu bar.
2. If groups are not visible in the Encryption Devices table, select View > Groups from the menu
3. Select an encryption group from the tree, and select Group > Tape Pools from the menu bar, or
FIGURE 53
FIGURE 54
4. Specify the Tape Pool Label Type. Tape pools can be identified by either a name or a number,
5. Enter a name for the tape pool. If you selected Number as the Tape Pool Label Type, the name
6. Select the Encryption Mode.
88
The Encryption Center dialog box displays.
bar.
The encryption groups display in the Encryption Devices table.
right-click the encryption group and select Tapepools.
The Add Tape Pool dialog box displays. The Name tape pool label type is the default; however,
you can change the tape pool label type to its number by selecting Number, shown in
Figure 54.
Add Tape Pool by name dialog box
Add Tape Pool by number dialog box
shown in Figure 53 and Figure
must match the tape pool label or tape ID/number that is configured on the tape
backup/restore application.
54.
Fabric OS Encryption Administrator's Guide
53-1001864-01