Quick Installation; Detailed Installation - Intel SRCU42E - Ultra320 SCSI PCI Express X8 RAID Storage Controller Hardware User's Manual

2.2

Quick Installation

The following steps are for for experienced computer users/installers. Section 2.3, "Detailed
Installation", contains detailed steps.
1) Attach the Intel® Portable Cache Module (Optional, required to enable Write Back
2) Turn power off to the server and all hard disk drives, enclosures, and system components
3) Follow the instructions in the host system documentation to open the cabinet of the host
4) Determine the SCSI ID and SCSI termination requirements.
5) Install the RAID Controller SRCU42E in the server, connect SCSI devices to it, and set
6) Perform a safety check:
7) Turn power on after completing the safety check.
2.3

Detailed Installation

This section provides detailed instructions for installing the Intel
SRCU42E.
1) Unpack
2) Attach the Intel® Portable Cache Module (Optional, required to enable Write Back
Quick Installation
Cache) or attach the memory DIMM to the RAID controller if the DIMM is not pre-
installed.
and remove the PC power cord.
system.
termination correctly on the SCSI channel(s).
– Ensure that all cables are properly attached.
– Ensure that the RAID Controller SRCU42E is properly installed.
– Close the cabinet of the host system.
Unpack and remove the RAID Controller SRCU42E. Inspect it for damage. If it appears
damaged, or if any items listed below are missing, contact your Intel support
representative. The Intel
◊
The Resource CD, which contains Intel RAID drivers for supported operating
systems, an electronic version of this guide, and other related documentation.
◊
A license agreement
Cache) or attach the memory DIMM to the controller if the DIMM is not pre-installed.
a. Remove the Intel® Portable Cache Module or memory DIMM from its packaging.
b. Open both DIMM socket levers on the RAID controller, noted by letter B in the
figure below.
c. Note the location of the alighment notch and insert the Intel® Portable Cache Module
or memory DIMM, lining up the slot in the Intel® Portable Cache Module or DIMM
with the alignment notch.
d. Push the Intel® Portable Cache Module or DIMM firmly into the card. See letter A
in Figure 2.1.
e. Make sure the socket levers latch securely.
®
RAID Controller SRCU42E is shipped with:
®
RAID Controller
20