Compaq 166207-B21 - Smart Array 5302/32 RAID Controller User Manual page 132

POST Error Messages
Table G-1: POST Error Messages
Message Description
1720 Slot x drive array – S.M.A.R.T. hard
drive detects imminent failure: SCSI
port x: SCSI ID y
1721 Slot x drive array – drive parameter
tracking predicts imminent failure
The following device(s) should be
replaced when conditions permit:
(a list of devices will be given here).
1723 Slot x drive array – to improve signal
integrity, internal SCSI connector
should be removed if external drives
are attached to the same SCSI port
(followed by further details).
1724 Slot x drive array – physical drive
position change(s) detected – logical
drive configuration has automatically
been updated.
1726 Slot x drive array – array accelerator
memory size change detected – array
accelerator configuration has
automatically been updated
1727 Slot x drive array – new logical drive(s)
attachment detected (if >32 logical
drives, this message will be followed
by Auto-configuration failed: too
many logical drives)
G-2
continued
Meaning and Recommended Action
The indicated drive has reported a
S.M.A.R.T. predictive-failure condition. It
may fail at some time in the near future.
Do not replace the drive unless all other
drives on the array are online! Back up
data before replacing drive(s).
Do not replace the drive unless all other
drives on the array are online! Back up
data before replacing drive(s).
M&P predictive failure threshold exceeded
condition. The indicated drive(s) may fail at
some time in the near future.
Follow the remaining instructions in the
POST message.
Logical drive configuration has been
updated automatically following physical
drive position changes. Press the F1 key to
resume.
This message is displayed if the controller
is replaced with a model that has a different
amount of cache memory.
The controller has detected an additional
array of drives that was attached when the
system was powered down. The logical
drive configuration information has been
updated to add the new logical drives. The
maximum number of logical drives
supported is 32 – additional drives will not
be added to the configuration if this number
is exceeded. Press the F1 key to resume.
Compaq Smart Array 5300 Controller User Guide
continued