Table of Contents
Advertisement
Technical Specifications
The design and implementation of the Intel
electromagnetic emissions, susceptibility to radio frequency energy, and the effects of
electrostatic discharge.
Table 2
Specification
Operating Voltage
Card Size
Array Interface to
Host
SAS Bus Speed
SAS Controller
SAS / SATA Ports
Firmware
Compatible Devices
Cabling
Redundant
Configuration
Enclosure
Management
LEDs
The host adapters have eight LEDs, labeled A0–A7, that turn green to indicate an activity
condition on any of the eight phys. There are eight Link Not Present LEDs, labeled
LNP0–LNP7, that turn yellow to indicate a fault condition on any of the eight phys. See
Figure 4
The host adapters have two light pipes routed through the PCI bracket. One light pipe
turns green to indicate activity on any phy. The other light pipe is bi-color. It flashes green
to indicate the adapter heartbeat, or it turns yellow when the adapter firmware detects a
fault condition.
12
lists the specifications for the Intel
+3.3 V, +12 V
Low-profile MD2 PCI Express* adapter card size (6.600 inches by 2.713
inches)
PCI Express* Rev 1.0A, x8 lane width 2.5 Gbps
3 GBps per port, point-to-point
One LSI* SAS 1068E controller
2x4 internal ports
2 MB in reflashable flash ROM
Mixed capacity, mixed SATA II and SAS in different enclosures; non-disk
devices, including expanders
•
Small, thin cables that do not restrict airflow
•
Shared connectors for multiple drive types
RAID configuration is stored and config on disk (COD)
In-band SES enclosure management support, including fault LEDs
(Expander backplane must be used in order to support fault LED. No fault
LED option is possible or expected in direct HDD connect mode).
for LED locations.
®
RAID Controller SASUC8I minimizes
®
RAID Controller SASUC8I.
Table 2. Specifications
®
Intel
RAID Controller SASUC8I
Intel® RAID Controller SASUC8I Hardware User's Guide
Advertisement
Table of Contents
