Table of Contents
Advertisement
1U Rackmount Enclosure
The 1U Rackmount enclosure is provided with either one or two of the
following supported tape drives already installed:
• LTO-3 (Model B) Half-Height, SCSI model TC-L33CX-EY-B
• LTO-3 (Model B) Half-Height, SAS model TC-L33CN-EY-B
• LTO-4 (Model B) Half-Height, SCSI model TC-L43CX-EY-B
• LTO-4 (Model B) Half-Height, SAS model TC-L43CN-EY-B
• LTO-5 Half-Height, SAS model TC-L53CN-AR
• LTO-6 Half-Height, SAS model TC-L62AN-BR
• LTO-7 Half-Height, SAS model TC-L72AN-BR
• LTO-8 Half-Height, SAS model TC-L82AN-BR
You can upgrade a single-drive enclosure to the two-drive configuration by
installing a second tape drive using any supported model of the same type
interface.
This guide references the instructions for installing the 1U Rackmount
enclosure in an equipment rack, and provides the procedures for:
• Connecting the drive interface and power cables
• Installing a second tape drive into the 1U Rackmount enclosure
Installation Guide
LTO-3, LTO-4, LTO-5, LTO-6, LTO-7 and
LTO-8
Contents
Cables .....................................................2
Replacing a Tape Drive ...........................4
Preinstallation Requirements .............4
Installation Procedure ........................4
SCSI Cable Configurations ...............12
a Rack ...................................................15
Tools Required ..................................15
Installation Procedure ......................15
Completing the Installation .............22
Class A Device Declarations..................24
Advertisement
Table of Contents
Need help?
Do you have a question about the LTO-8 and is the answer not in the manual?
Questions and answers