Table of Contents
Advertisement
Quick Links
INSTALLER: Leave this manual with party responsible for use and operation.
OWNER: Retain this manual for future reference.
NOTICE: DO NOT discard this manual!
QUARTZ
SERIES
Models:
This appliance may be installed as an OEM
installation in manufactured home (USA
only) or mobile home and must be installed
in accordance with the manufacturer's
instructions and the Manufactured Home
Construction and Safety Standard, Title 24
CFR, Part 3280 in the United States, or the
Standard for Installation in Mobile Homes,
CAN/CSA Z240 MH Series, in Canada.
This appliance is only for use with the type(s)
of gas indicated on the rating plate. This
appliance is not convertible for use with other
gases, unless a certified kit is used.
In the Commonwealth of Massachusetts installation must be
performed by a licensed plumber or gas fitter.
See Table of Contents for location of additional Commonwealth
of Massachusetts requirements.
Majestic • QUARTZ32, QUARTZ36, QUARTZ42 Installation Manual • 2412-980 Rev. Q • 3/19
Installation Manual
Installation and Appliance Setup
WARNING:
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly
could result in serious injury, death, or
property damage.
• DO NOT store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.
• What to do if you smell gas
- DO NOT try to light any appliance.
- DO NOT touch any electrical switch. DO
NOT use any phone in your building.
- Leave the building immediately.
- Immediately call your gas supplier from
a neighbor's phone. Follow the gas sup-
plier's instructions.
- If you cannot reach your gas supplier, call
the fire department.
• Installation and service must be performed
by a qualified installer, service agency, or the
gas supplier.
DANGER
DO NOT TOUCH GLASS
NEVER ALLOW CHILDREN
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and shall be installed for
the protection of children and other at-risk
individuals.
HOT GLASS WILL
CAUSE BURNS.
UNTIL COOLED.
TO TOUCH GLASS.
1
Advertisement
Table of Contents
Related Manuals for Majestic QUARTZ36
Summarization of Contents
Product Specific and Important Safety Information
Appliance Certification
Details appliance certification standards and manufacturer.
Glass Specifications
Information on tempered glass safety standards and requirements.
BTU Specifications
Lists the BTU output for different models and gas types.
High Altitude Installations
Guidelines for installing the appliance at higher elevations.
Non-Combustible Materials Specification
Defines materials that do not ignite or burn.
Combustible Materials Specification
Defines materials that can ignite and burn.
Electrical Codes
Outlines electrical wiring and grounding requirements based on codes.
California
Safety warning specific to California regarding chemical exposure.
Requirements for the Commonwealth of Massachusetts
Specific installation requirements for Massachusetts.
Getting Started
Design and Installation Considerations
Key factors to consider before appliance installation.
Good Faith Wall Surface/TV Guidelines
Guidance on wall surface temperatures and TV placement above the appliance.
Tools and Supplies Needed
List of necessary tools and building supplies for installation.
Inspect Appliance and Components
Instructions for checking the appliance and its parts before installation.
Framing and Clearances
Appliance/Decorative Front Dimension Diagrams
Diagrams showing appliance dimensions for framing purposes.
Clearances to Combustibles
Specifies required air space clearances to combustible materials.
Constructing the Appliance Chase
Guidelines for building a chase structure for the appliance and vent.
Termination Location and Vent Information
Vent Termination Minimum Clearances
Minimum clearance requirements for vent termination locations.
Chimney Diagram
Diagram illustrating vent terminal clearances and prohibited areas.
Approved Pipe
Details approved rigid and flexible vent pipe types.
Use of Elbows
Explains the use of elbows and their effect on vent length.
Measuring Standards
Standards used for measuring vent pipe lengths and offsets.
Use of Flex Vent (SLP-FLEX Series 6-5/8 Inch)
Guidelines for using flexible vent pipes, including support and installation.
Vent Diagrams
General rules and diagrams for vent system configurations.
Vent Clearances and Framing
Pipe Clearances to Combustibles
Crucial clearances and warnings for vent pipes near combustibles.
Wall Penetration Framing/Firestops
Instructions for framing wall penetrations and installing firestops.
Ceiling Firestop/Floor Penetration Framing
Guidance on framing ceiling penetrations and installing ceiling firestops.
Install Attic Insulation Shield
Requirements and instructions for installing attic insulation shields.
Appliance Preparation
Vent Collar Preparation
Steps for preparing the vent collar before connecting vent sections.
Installing the Optional Heat-Zone® or Heat-Duct Gas Kit
Instructions for installing optional heat distribution kits.
Securing and Leveling the Appliance
How to properly position, secure, and level the appliance.
Venting and Chimneys
Assemble Vent Sections
Detailed steps for assembling DVP and SLP vent sections.
Assemble Slip Sections
Instructions for assembling slip sections of the vent system.
Secure the Vent Sections
Guidance on supporting and securing vent pipe sections.
Disassemble Vent Sections
Procedures for safely taking apart vent sections.
Vertical Termination Requirements
Requirements for vertical vent termination, including roof flashing.
Horizontal Termination Requirements
Heat shield requirements for horizontal vent termination.
Electrical Information
General Information
Overview of electrical requirements, codes, and safety warnings.
Wiring Requirements
Details wiring for the Intellifire ignition system, including transformer and battery options.
Gas Information
Fuel Conversion
Information on converting the appliance for different gas types.
Gas Pressure
Required gas pressures for optimal appliance performance.
Gas Connection
Steps for connecting the gas supply line to the appliance.
High Altitude Installations
Guidelines for installing the appliance at higher elevations.
Air Shutter Setting
Adjusting air shutter for optimal flame appearance based on vent configuration.
Burner Identification/Verification
How to identify and verify burner components for service.
Finishing
Facing Material
Guidelines for applying facing materials around the appliance.
Mantel and Wall Projections
Clearances and requirements for mantels and wall projections.
Decorative Front Finishing
Information on finishing decorative fronts and allowed material thickness.
Appliance Setup
Remove Fixed Glass Assembly
Instructions for safely removing the fireplace's fixed glass assembly.
Remove Shipping Materials
Steps to remove protective packaging and materials from the appliance.
Clean the Appliance
Guide to cleaning sawdust and debris from the appliance.
Install Logs
Detailed instructions for placing logs and embers for specific models.
Install Fixed Glass Assembly
Instructions for reinstalling the fixed glass assembly after setup.
Install Majestic Decorative Front and Hood
Steps for attaching decorative fronts and hoods to the appliance.
Reference Materials
Vent Components Diagrams
Visual guides and specifications for various vent system components.
Accessories
Information on optional accessories like remote controls, fans, and kits.
Need help?
Do you have a question about the QUARTZ36 and is the answer not in the manual?
Questions and answers