Installer Guide Uno-Ts2 Overview - Russound UNO-TS2 Instruction Manual

UNO-TS2 Overview for Installers
Note: The following minimum firmware revisions are required for use with the UNO-TS2:
CAV6.6 Rev. 3
CAV6.6 Rev. 4
CAM6.6
CAM Internal AM/FM Tuner
CAM Internal XM Module
ST2 Dual Tuner
ST2-XM (ST2 Chassis)
ST2-XM (XM Module)
ST2S Tuner (Sirius)
SMS3 Media Server
The UNO-TS2 is an RNET-system enabled touch-
screen that functions similarly to the UNO-S2
keypad. It fits into a double-gang 32ci low volt-
age PVC junction box, uses a CAT-5 110 punch-
down connection, and supports one external IR
receiver. Active system status icons appear on
the screen (shared, master, party and do not dis-
turb). An "All On" or "All Off" can be performed
by pressing and holding the power button.
Controller Configurations
For One UNO-TS2 per Controller
An RNET controller (CAV6.6, CAM6.6) can
support ONE UNO-TS2 touchscreen AND
up to five UNO keypads per controller,
connected directly to the controller via the UNO
System Keypad Ports.
For 2 to 6 UNO-TS2s per Controller
(One UNO-TS2 per Zone)
After the first UNO-TS2, any additional
UNO-TS2s must be connected to the con-
troller via an SA-ZX3 Keypad Splitter. The SA-ZX3
is powered by a 1 amp 1201A power supply with
an RJ45 CAT-5 patch cable to connect to the
controller's UNO Keypad Port. UNO-S1/S2 key-
pads can share the SA-ZX3 with an UNO-TS2, but
they must be configured for the same zone.
2.01.16 or higher
3.01.10 or higher
1.01.05 or higher
1.01.01 or higher
2.00.05 or higher
3.00.10 or higher
3.00.10 or higher
2.00.05 or higher
1.00.10 or higher
2.00.07 or higher
After sources are configured in the RNET sys-
tem, they must be set up in the UNO-TS2 using a
simple onscreen process under Installers Setup.
The configured source names (up to 6 sources)
appear on the UNO-TS2 main screen, and unas-
signed source buttons remain blank. Standard
source names are assigned through the
CAV6.6/CAM6.6. PC Power Tool programming is
needed for any custom naming of sources,
including "iPod."
The UNO-TS2 uses pre-configured source tem-
plates. Due to the unique source screens, the
UNO-TS2 does not support the key mapping fea-
tures of the UNO-S1/S2 keypads. Custom key
configuration (Key Configuration menu of con-
troller) is not recommended and may result in
unexpected behavior by the UNO-TS2.
The UNO-TS2 may require future updates for
screens and for firmware. These updates are
performed in a similar fashion as UNO-S2
updates, with a programming cable
(P/N 2500-121036) and a PC.
INSTALLER GUIDE
UNO-TS2 Overview
17