Bernina Artista 640 User Manual page 95

Embroidery Settings 1
Embroidery Settings 2
«Adjust Reference Position» calibrates the
needle to the center of the embroidery hoop.
Adjustments can only be activated if the
embroidery module and the oval embroidery
hoop are attached. It is only necessary to
adjust the Reference Position once as the
same setting changes will apply to all the
hoops.
• insert the embroidery template into the
hoop
• touch «Check»
• the display changes
• the hoop position is read and the needle
positioned in the middle
• if the needle is now not positioned exactly
over the center point of the template, it has
to be adjusted with the arrows
• touch «OK»
• the adjustment will be saved, the display
closes and the selection menu appears
• touch «To Next Page»
• in theis screen the embroidery speed can be
adjusted
Thread Tension Correction
• turning stitch length knob or touching «+»
or «–» changes the basic setting (0) of the
upper Thread Tension by plus or minus
20%
0 = basic settings (factory settings)
1 = + 10%
2 = + 20%
-1 = - 10%
-2 = - 20%
• this correction fine tunes the basic tension
setting on your sewing computer, which
may be affected by variables such as thread
weight, etc.
• the number in the bar and the blue
background of the «+» or «–» reflect the
changes
• the «Reset» on-screen button returns you
to the basic settings
• tension adjustments affect all stitches and
remain saved, also when the sewing
computer is turned off.
Setup-Program
Motor Speed
• turning stitch width knob or touching «+»
or «–» changes the basic settings of the
speed by 6-10 stitches
• the number in the bar reflects the stitches
per minute, the basic settings are indicated
by a dark bar
Auto Thread Cutter
• when the bar is active (blue) the upper
thread and bobbin thread are automatically
cut
• when the bar is inactive (x) the Automatic
Thread Cutter is off
• touching the bar «Auto Thread Cutter»
activates or deactivates the function
95