Event Monitoring; Spot-Out Monitoring - Samsung SHR-5042 User Manual

Zoom function
The Zoom function doubles the size of the selected area
but it is active only in the full screen mode.
The zoom setup area appears when the
is pressed in the full screen mode. You can adjust the
location of the zoom setup area by using the
() buttons. If you press the
after selecting a setup area, the selected area is shown
twice as big as the previous size. The image location can
be adjusted by using the
even after enlarging the size. If the
pressed again under the enlarged state, it will return to
the zoom setup area and you can perform the Zoom Off
function by using the

EVENT MONITORING

The event monitoring function displays the channel
linked to the event when a specific event (sensor/motion)
occurs. The event monitoring On/Off and event Duration
functions can be set by using the command "
" "  "
When the event monitoring time has been set to 5
seconds, for example, the channel-2 appears for 5
seconds in the full screen mode if an event initially occurs
in the channel-2 as shown in the figure below. If another
event occurs within 5 seconds, it is also displayed
together with the existing event.
SHR-5042_Eng.indb 19
button
( ) button
() buttons
( ) button is
button.
" 
".
When events occur from the channels 1 and 3 within 5
seconds after an event has occurred in the channel 2 (as
shown in the figure). Then, the channels 1, 2 and 3 are
switched to the full screen.
If no new event occurs within the event display duration,
it will return to the previous live mode. If you press the
button before the event display time exceeds,
the event monitoring stops. If an event occurs, the
ALARM LED lights and the ALARM LED is turned off if
you press the button while the LED lights.
The alarm setting is initialized when the
is pressed. In this case, the Event icon disappears. The
monitoring function can be cancelled while in event
monitoring. The event recording with pre-event time and
post-event time resumes after a new alarm occur.

SPOT-OUT MONITORING

The Spot-out monitoring is the function that monitors
the entire screen of a specific channel with the output
different from the live screen output. If a monitoring item is
selected from the menu screen, you can select a specific
channel as the Spot-out channel among the channels
1 to 4 and you can also monitor all the channels at an
interval of auto sequence time. The live screen icons do
not appear for Spot-out monitoring.
At this time, the auto sequence time internal is identical
to the auto sequence time of the live mode.
If the Spot-out event monitoring is active, the channel
where an event occurs can be regarded as the Spot-
out output. If events occur simultaneously from several
channels, the channel with the lowest number has priority
and is output to the Spot-out.
button
live _19
2007-06-08 ｿﾀﾈﾄ 1:24:34