Controls, Connectors And Indicators - JVC TK-C700U - Color Cctv Camera Instructions Manual

Controls, connectors and indicators

Ceiling mount
3 2
(Front)
4
5
6
7
(Back: Camera side)
VIDEO OUTPUT terminal
1
Outputs composite video signals and is to be connected
to a monitor, etc. (Output impedance 75ohm)
Control signal terminals
2
The camera can be controlled by RS-422A or RS-485 sig-
nals.
AC 24V input terminals
3
Input the 24 V AC power.
Isolated power only (E type)
Class 2 only (U type)
Drop prevention wire
4
Engage this wire in the drop prevention wire hook
the camera.
Mounting holes ( 4)
5
Use these holes to attach the ceiling mount to the ceiling.
Camera connector (male)
6
Connects with the camera connector
Lock screw
7
Use this screw to fasten the camera clamp
camera.
Camera position alignment mark
8
Align with the mark
17
the ceiling mount.
9 Safety wire hole
To prevent the camera from dropping accidentally, pass a
4
10
1
9
8
5
on the camera.
13
to fix the
14
when mounting the camera onto
Camera body
14
Dome cover
View when the camera body
cover
15
safety wire from the ceiling through these holes.
Terminal board cover
10
Protects the cable connection terminals against dirt, etc.
11 Control signal termination switch (TERM)
This is a termination ON/OFF switch for the input signals
to the control signal terminal
"RX+" to "RX–" route is terminated via 110 resistor.
Hook for attaching the drop prevention wire
12
Attach the drop prevention wire
13 Camera connector (female)
Connects with the camera connector
mount.
12 on
14 Camera clamp
Fix the camera body to the ceiling mount by fastening the
lock screw
Camera body cover
15
Remove this cover when using the setting switches
16 Setting switches
Set the PROTOCOL, etc.
Ref. "Switch settings" on page 6.
17 Camera positioning alignment mark
When mounting the camera onto the ceiling mount ,align it
with the mark
18 Ventilation
This is the ventilator for the internal cooling fan.
CAUTION
Make sure that nothing interferes with the ventilator when
installing the camera.
12
13
Dome cover lens
is removed
2 . When it is set to ON, the
4
7 to this clamp.
.
8
11
15
16
Camera position
17
alignment mark
18 Ventilation
to this hook.
6 on the ceiling
16 .