Connections - JVC TK-C700U - Color Cctv Camera Instructions Manual

Connections

CAUTION
If this camera and the cables connected to this camera is used where there are strong electromagnetic waves or where there
is magnetism present, for example near a radio or TV transmitter, power transformer or an electric motor, the picture may
produce noise and the colors may be affected.
Optional controller is required to use the TK-C675B camera. Please contact your local dealer or installer for more information
about this controller.
When the system is composed of a single camera
24V AC
When the system is composed of more than one camera
CAUTION
Be sure to terminate the control signal cable at both ends. The cables (length of stub) connecting to non-terminated equipment
(camera or controller) must be as short as possible. If the length of stub is long, control may not be made correctly.
When the controller is not located at the end.
CAM1
PROTOCOL(1) : ON
MACHINE ID : 01
TERM
• Set the TERM switches of the cameras at both ends
(CAM1 and CAM32) to ON, and TERM switches of the
other cameras to OFF.
• Do not terminate at the controller.
When the controller is located at the end.
CAM1
PROTOCOL(1) : ON
MACHINE ID : 01
TERM
• Set the TERM switch of CAM1 to ON, and also, terminate at the controller with 110 ohm.
Set the TERM switches of the other cameras to OFF.
8
CONTROL
VIDEO OUT
PROTOCOL(1) SW4 :OFF
TERM : ON
length of stub
CAM2
PROTOCOL(1) : ON
MACHINE ID : 02
: ON TERM : OFF
length of stub
CAM2
PROTOCOL(1) : ON
MACHINE ID : 02
: ON TERM : OFF
CONTROL Cable
length of stub
PROTOCOL(1) : ON
MACHINE ID : 31
CONTROLLER*
TERM
VIDEO
SWITCHER, etc.
CONTROL Cable
PROTOCOL(1) : ON
MACHINE ID : 32
TERM
Controller*
Monitor
length of stub
CAM31 CAM32
PROTOCOL(1) : ON
MACHINE ID : 32
: OFF TERM
length of stub
CAM32
CONTROLLER*
: OFF
VIDEO
SWITCHER, etc.
: ON
Terminate it
with 110ohm.