Repairs; Transfer And Disposal - Bosch NBN-498-11P Installation And Operation Manual

Dinion2X IP Camera
Note:
You must reboot to activate the new IP address, a new subnet
mask or a gateway IP address.
Reboot
Briefly interrupt the power supply to the camera for a reboot
(disconnect the power supply unit from the mains supply and
switch on again after a few seconds).
Additional Parameters
You can use the terminal program to check other basic
parameters and modify them where necessary. Use the on-
screen commands in the various submenus to do this.
12.3

Repairs

CAUTION!
Never open the casing of the unit. The unit does not contain any
user serviceable parts. Ensure that all maintenance or repair
work is performed only by qualified personnel (electrical
engineering or network technology specialists). In case of
doubt, contact your dealer's technical service center.
12.3.1

Transfer and disposal

The camera should only be passed on together with this
installation guide. The unit contains environmentally hazardous
materials that must be disposed of according to law. Defective
or superfluous devices and parts should be disposed of
professionally or taken to your local collection point for
hazardous materials.
Bosch Security Systems Installation and Operation Manual
Maintenance | en 125
AR18-10-B006 | v1.1 | 2010.06