Wiring Diagram - Desa CDCFTN Owner's Operation And Installation Manual

CLEANING AND
MAINTENANCE
Continued
5. Blow air into the primary air holes on the injector holder.
6. In case any large clumps of dust have now been pushed into
the burner repeat steps 3 and 4.
Clean the pilot assembly also. A yellow tip on the pilot flame
indicates dust and dirt in the pilot assembly. There is a small pilot
air inlet hole about two inches from where the pilot flame comes out
of the pilot assembly (see Figures 51 or 52 depending on model).
With the unit off, lightly blow air through the air inlet hole. You may
blow through a drinking straw if compressed air is not available.
Burner
Tube
Primary Air
Inlet Holes
Figure 50 - Injector Holder On Outlet Burner Tube
Pilot Air Inlet Hole
Pilot Assembly
Figure 51 - Pilot Inlet Air Hole
(Propane/LP Gas)
LOG SET
• If you remove one-piece log set for cleaning, refer to Installing
Log Set and Screen, page 19, for placement instructions.
• Replace log set if broken or chipped (dime-sized or larger).
CABINET
Air Passageways
• Use a vacuum cleaner or pressurized air to clean.
Exterior
• Use a soft cloth dampened with a mild soap and water mixture.
Wipe the cabinet to remove dust.
For more information, visit www.desatech.com
For more information, visit www.desatech.com
111244-01A
Cleaning Burner Injector Holder and Pilot Air Inlet Hole (Cont.)
Injector Holder
Pilot Air Inlet Hole
Pilot Assembly
Figure 52 - Pilot Inlet Air Hole
(Natural Gas)
CLEANING AND MAINTENANCE

WIRING DIAGRAM

(Remote-Ready Models Only)
Black
Auto
Off Switch
Red
On
Red
Thermopile
White
25
25
Log Set
Cabinet
WIRING DIAGRAM
TPTH TH
Gas Control
TPTH TP