Desa CDCFTN Owner's Operation And Installation Manual page 17

INSTALLATION
Continued
OPTIONAL WIRELESS HAND-HELD REMOTE
CONTROL ACCESSORIES
Remote-Ready Models Only
([C]GHRCB Series & [C]GHRCTB Series)
Installing Receiver
1. Disconnect wires from the control valve (see Figure 26) .
2. Locate the battery clip mounted on the back of the receiver
(see Figure 27).
3. Slide 9-volt battery (not included) through the clip.
4. Attach the terminal wires to the battery (see Figure 27).
5. Connect wires from remote receiver to control valve as shown
in Figure 28.
6. Install remote receiver unit onto remote/blower bracket using
screws provided (see Figure 28).
Figure 26 - Disconnecting Wires From Control Valve
Receiver
9-Volt Battery
Figure 27 - Attaching Battery to Receiver
White Wire to
TH Terminal on
Control Valve
Remote
Receiver
Figure 28 - Installing Remote Receiver
For more information, visit www.desatech.com
For more information, visit www.desatech.com
111244-01A
Optional Wireless Hand-Held Remote Control Accessories [Remote-Ready Models Only]
Battery Clip
Red Wire to TPTH
Terminal on Control
Valve
Installing 9-Volt Battery in Hand-Held Remote
Control Unit
1. Remove battery cover on back of remote control unit.
2. Attach terminal wires to the battery (not included). Place bat-
tery into the battery housing.
3. Replace battery cover onto remote control unit.
Terminal
Wires
9-Volt
Battery
Figure 29 - Installing Battery in Hand-Held Remote Control Unit
(GHRCB and CGHRCB Series)
9-Volt
Battery
Battery
Housing
Figure 30 - Installing Battery in Hand-Held Remote Control Unit
(GHRCTB and CGHRCTB Series)
Terminal
Wires
INSTALLATION
Battery Cover
Battery
Housing
Terminal Wires
17
17
Remote
Control Unit
Remote
Control Unit
Battery Cover