Advertisement
Table of Contents
Cable/Cord Spider
Parts
Instructions For Hanging
Step 1
Push Saucer up through large hole in bottom of
spider anchor. Fig. 1
Slide Saucer into pocket next to the hole. Pull
cable tight.
Step 2
Slide loop end of cable around center of
MultiClip. Holding clip at slight angle, first insert
one round end, then press down on other end and
push MultiClip into holder. Repeat for second
MultiClip. Fig. 2
Note: For directions on how to use a specific
holder to hang your poster, refer to the appropri-
ate instruction sheet.
The Spider Anchor is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSCCSpiderAnchorLoopSaucer
Incept-9.12.02
TM
Anchor with Loop and Saucer
1 Spider Anchor
RAN-BASE-CC
1 Loop and
Saucer
16-0018SL
1UP-0100
Figure 1
Figure 2
35 Congress Street, Salem MA 01970
Tel# 1-800-631-9707 Fax# 1-800-560-2890
Instruction Sheet
1
MultiClip
e-mail:signware@rosedisplays.com
Advertisement
Table of Contents
Related Manuals for ROSE DISPLAYS RAN-BAS-CC WITH LOOP AND SAUCER AND MULTICLIPS
Summary of Contents for ROSE DISPLAYS RAN-BAS-CC WITH LOOP AND SAUCER AND MULTICLIPS
- Page 1 Figure 2 The Spider Anchor is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products.
- Page 2 Figure 2 The Spider Anchor is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products.
Need help?
Do you have a question about the RAN-BAS-CC WITH LOOP AND SAUCER AND MULTICLIPS and is the answer not in the manual?
Questions and answers