ROSE DISPLAYS QUICKGRIP WITH PEGS AND MULTICLIPS Manual

QuickGrip™ with Peg

Parts

Instructions for Hanging

Step 1

When using QuickGrip to hang 1/8" Sintra
or an equally heavy substrate, have your
printer punch two 1/4" holes along the top
and bottom edges of print — or only the top
if no bottom holder is being used. Fig. 1
Note: Each hole must be centered 1/4" in
from the edge of the substrate.

Step 2

Push both parts of the peg together through
each of the punched holes. Fig. 2

Step 3

Slide QuickGrip onto substrate. The pegs
should slide into the side rails. Fig. 3
Note: This is the easiest way to safely hang
heavier substrates.

Step 4

Squeeze sides of MultiClip together. Fig. 4
Align the bottom rail of the MultiClip with
the top channel of the plastic holder. Slide
MultiClip into rail. Fig. 5 Repeat step 3
for second MultiClip.

Step 5

Push end caps into place. Fig. 6

Step 6

Suspend poster. Fig. 7
QuickGrip is a trademark of Rose Displays, Ltd. Neither the manufacturer
nor any sales agent may be held liable for injury, loss or damage resulting
from the use of these products.
Part #03INSQuickGripPegMC
Incept-3.11.03
2
QuickGrip Multiclips
12-0500 1UP-0101
2
4

End Caps

06-5525
Figure 1 Figure 2
Figure 4
Figure 6
Instruction Sheet
2
Pegs
06-1920
Figure 3
Figure 5
Figure 7
35 Congress Street, Salem, MA 01945
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com