Cisco 15454-GBIC-LX= - 1000 Mbps GBIC Expansion Slot Hardware Installation Manual page 52

Mounting the Access Point
From the pole mount kit, use the two short bolts, lock washers, and flat washers to loosely attach the two
Step 5
adjustment plates as shown in
Note
Figure 2-10
If necessary, rotate the access point until the top edge of the housing is horizontal, and tighten the two
Step 6
short bolts on the adjustment plates. Torque the bolts to 15 to 20 ft. lbs. (20 to 27 Nm).
Step 7 Continue with the
Cisco Aironet 1500 Series Outdoor Mesh Access Point Hardware Installation Guide
2-20
C i s c o C o n f i d e n t i a l - D r a f t 1
Figure
Do not over-tighten the bolts. You will need to adjust the access point orientation.
Access Point Attached to the Pole Clamp
"Grounding the Access Point" section on page
2-10.
Chapter 2 Mounting Instructions
2-21.
OL-9977-05