Cisco 15454-GBIC-LX= - 1000 Mbps GBIC Expansion Slot Hardware Installation Manual page 50

Mounting the Access Point
From the pole mount kit, use four of the supplied short bolts, lock washers, and flat washers to attach
Step 1
the pole mount kit adjustment plate to the access point mounting plate as shown in
the bolts to 15 to 20 ft. lbs. (20 to 27 Nm).
Figure 2-8
Select a mounting location. You can attach the access point to any pole from 1.66 to 3.35 in. (4.22 to
Step 2
9.02 cm) in diameter.
Note
Loosely assemble the pole clamp components around the pole and thread the four long bolts into the
Step 3
clamp adjustment plate.
plate positioned on the bolts.
Cisco Aironet 1500 Series Outdoor Mesh Access Point Hardware Installation Guide
2-18
C i s c o C o n f i d e n t i a l - D r a f t 1
Adjustment Plate Attached to the Mounting Plate
If you will be using a streetlight power tap adapter, position the access point within 3 ft (1 m) of
the outdoor light control.
Figure 2-9 shows the pole clamp attached to a pole with the clamp adjustment
Chapter 2 Mounting Instructions
Figure 2-8. Tighten
OL-9977-05