Verifying Controller Association; Access Point Power - Cisco 15454-GBIC-LX= - 1000 Mbps GBIC Expansion Slot Hardware Installation Manual

Verifying Controller Association

Verifying Controller Association
To verify that your access point is associated to the controller, follow these steps:
Step 1 Log into your controller web interface (HTTPS) using a web browser.
Note
Step 2 Click Wireless and verify that your access point MAC address is listed under Ethernet MAC.
Step 3 Logout of the controller and close your web browser.

Access Point Power

The access point does not have an LED to indicate available power.
No serviceable parts inside. Do not open.
Caution
To ensure that your access point has power after installation, perform these steps:
Step 1 Ensure that the access point power source is turned-off.
Remove and reconnect the AC power or Ethernet connector that supplies power to the access point.
Step 2
Note
Step 3 Ensure that all other cable connectors are properly connected.
Step 4 Turn-on the power source for the access point.
Cisco Aironet 1500 Series Outdoor Mesh Access Point Hardware Installation Guide
3-4
You can also use the controller CLI show ap summary command from the controller console
port.
Hand-tighten the connector until the connector locks.
Chapter 3 Troubleshooting
OL-9977-05