Installation - Kenmore 4048 - Pro 29.5 cu. Ft Installation Instructions Manual

iNSTALLATiON SPACE
1_ *Finished Width
84-1/2" max.
83-1/2" min.
Finished
Opening
3"
74" From
Floor to
Bottom of
Electrical
3-1/2"
* The finished cutout width must be 47=1/2"
for 48" models.
Water and Electrical Locations
The opening must be prepared with the electrical
and water supply located as shown.
Cutout Depth
The cutout depth for the refrigerator must be at
least 24 inches so that the refrigerator will be flush
with the adjacent cabinets, countertops or wails.
Additional Specifications
,, A 115 volt, 60Hz, 15 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be
located on rear wall as shown.
NOTE: GFI (ground fault interrupter) is not
recommended.
,, The refrigerator should always be plugged into
its own individual electrical outlet which has a
voltage rating that matches the rating plate.
,, Water line can enter the opening through the
floor or rear wall. The water line should be used
to connect the cold water line and the water
connection location. The line should be long
enough to extend to the front of the refrigerator.
Installation of an easily accessible shutoff valve
in the water line is required.
• It is recommended that you use a mat to
prevent the floor from any possible damage.
DIMENSIONS AND CLEARANCES
25-3/8" Case Depth
**Case Width
84" From
"81-3/4" Floorto
at Rear Top Frame
Frameto Frame for 48" Models
Depth Including
Handles 26-7/8"
* Shipping Height: front height may be adjusted
from 83-1/2" to 84-1/2" by adjusting front and
rear leveling legs a maximum of 1 inch.
**Case Width: must be 47" for 48" models.
Product Clearances
This refrigerator is equipped with a 2-position door
stop. The factory set 130 ° door swing can be
adjusted to 90 ° if clearance to adjacent cabinets
or walls is restricted.
130 ° Door Swing 90 ° Door Swing
I
II: tt
LI .....
I_D4
23-7/8"
Behind
Frame
C
I-D*!
A B C D
13-7/16" 18-9/16" 28" 4"
Allow minimum clearances for Freezer door
(Dimension A) and Fresh Food door (Dimension B)
for a full 130 ° door swing and to allow for drawer
removal.
Four inch (4") minimum clearance is required when
door swing is adjusted to 90 °. If the 90 ° door stop
position is used, drawer access is maintained, but
drawer removal is restricted.
3