System Setup - Sherwood RD-6502 Operating Instructions Manual

System Setup

• The setup menu is displayed on the fluorescent display and allows you to perform the setup procedures easily. In
most situations, you will only need to set this once during the installation and layout of your home theater, and it
rarely needs to be changed later.
The setup menu consists of 5 main menus ; system, input, speaker setup, CH level and parameter. These menus
are then divided up into various sub-menus.
■Navigating through the setup menu
• The explanations here assume you are using the buttons on the remote control when performing the setup menu
operation. However, you can use the buttons on the front panel as well.
The buttons on the front panel correspond to those on the remote control as shown below.
.
1
Turn the setup menu on.
.
2
Select the desired menu using the CURSOR UP(▲)/DOWN(▼) buttons.
.
3
Confirm your selection.
• The setup menu will be shown.
• To turn the menu off, press this button again.
• When selecting "SYSTEM", see "SETTING THE
SYSTEM" on page 31.
• When selecting "INPUT", see "SETTING THE
INPUT" on page 32.
• When selecting "SPK SET", see "SETTING THE
SPEAKER SETUP" on page 34.
• When selecting "CH LEVEL", see "SETTING THE
CH LEVEL" on page 38.
• When selecting "PARAMTR", see "SETTING THE
PARAMETER" on page 40.
• When selecting "EXIT", the setup menu will be
turned off.
29