Related Manuals for HMS Intesis Modbus RTU
Summarization of Contents
Description
1.1 Introduction
Introduces the Intesis Modbus RTU to Modbus TCP Router and its purpose.
1.2 Functionality
Explains how Intesis routes Modbus communications and its transparent data mapping.
1.3 Router capacity
Details the device's capacity, including supported Modbus RTU and TCP slave devices.
Connections
Power Supply
Specifies requirements for NEC Class 2/LPS/SELV rated power supply and polarity.
Ethernet
Instructions for connecting to the IP network via Ethernet CAT5 cable.
Port Modbus RTU
Connects the EIA485 bus to the Modbus RTU port, respecting polarity and termination.
2.1 Powering the device
Details power supply connection and a warning about earth loops.
2.2.1 Modbus TCP
Connects the communication cable from the network hub or switch to the ETH port.
2.2.2 Modbus RTU
Connects the EIA485 bus to the Modbus RTU port, noting bus characteristics.
2.3 Connection to the configuration tool
Explains how to connect to the PC for configuration and monitoring via Ethernet.
Set-up process and troubleshooting
3.1 Pre-requisites
Lists requirements for setting up the device, including connected clients and cables.
3.2 Intesis MAPS Configuration & monitoring tool
Introduces Intesis MAPS software for monitoring and configuring Intesis Modbus series devices.
3.2.2 Connection
Explains how to configure Intesis connection parameters using the MAPS software.
3.2.3 Configuration tab
Details the Configuration tab in Intesis MAPS for general, Modbus slave, and Modbus router parameters.
3.2.4 Signals
Lists available signals, their Modbus registers, and parameters in the MAPS Signals tab.
3.2.5 Sending the configuration to Intesis
Describes the steps to save, generate, and send the configuration file to the Intesis device.
3.2.6 Diagnostic
Explains the diagnostic tools and viewers in the Configuration Tool for commissioning and troubleshooting.
3.3 Set-up procedure
Provides a step-by-step guide for installing and setting up the Intesis device and software.
Need help?
Do you have a question about the Intesis Modbus RTU and is the answer not in the manual?
Questions and answers